Ultra Bee Supermoto Wheel Kit

Ultra Brake Kit for LBX / E-Ride

Upgrade your rear braking system with a motorcycle-style foot brake setup designed for the Surron Light Bee X (LBX) and E-Ride Pro.

Kit Includes:

➤Pre-bled hydraulic brake system with DOT 5.1 brake fluid
➤1× Ultra Bee brake caliper
➤1× Moto foot brake assembly
➤1× Moto brake line
➤Ready to bolt up and ride

⚠️ IMPORTANT: READ BEFORE YOU BUY — FITMENT GUIDE

To avoid returns and installation issues, please review these compatibility requirements before ordering. Bracket and brake configuration compatibility is highly specific to your bike setup.

🔧 Compatible With:

➤Surron Light Bee X (LBX): Direct fit for standard frames/swingarms.

➤E-Ride Pro SS 2.0 (2024–2025+): Fits the frame axle slot but requires proper alignment and spacing.

➤Single-Caliper Configuration: Designed for riders running ONE rear caliper controlled by the foot brake.

❌ NOT Compatible With:

➤Dual-Caliper Setups: This is a single-caliper bracket only and does not provide mounting points for two rear calipers. If you want to retain your handbrake while adding a foot brake, a dual-caliper bracket is required.

➤Oversized Moto Calipers: The single-caliper bracket is designed for an OEM/stock bicycle-style hydraulic caliper or compatible drop-in replacements such as Hope, Hayes, or Lewis. It is not designed for large motorcycle-style calipers, including the Surron Ultra Bee rear caliper.

➤Direct E-Ride Pro OEM Frame Brackets: This bracket replaces/modifies the existing brake carrier arrangement. It does not directly bolt onto the stock E-Ride Pro 2.0 factory caliper mount without replacing the bracket.

⚙️ Installation & Technical Notes

Rotor Clearance: Depending on your wheel, hub, and spoke configuration, minor shims or washers may be required to properly center the caliper and prevent spoke or rotor interference.

Hand-Brake Configuration: The single-caliper setup dedicates the rear caliper to the foot brake. If you want both hand and foot braking, you must use a compatible dual-caliper bracket.

240mm Rotor Required: Our moto brake brackets are designed specifically for 240mm moto brake rotors. Verify rotor compatibility before ordering.

Professional Installation Recommended: Swingarm geometry, wheel offsets, and spacing can vary by model year. Professional installation is strongly recommended to ensure proper alignment, braking performance, and rider safety.

⚠️ Please verify your exact bike model, year, brake configuration, bracket type, and rotor compatibility before purchasing.